Tag Archives: raid

How can I tell if I'm using hardware or software RAID?

Tweet about this on TwitterShare on Google+Share on RedditShare on LinkedInShare on FacebookBuffer this page

I recently acquired an HP Proliant DL380 2U rackmount server. One can reasonably expect a rackmount server boasting 6 hot-swappable hard drive bays also to sport hardware RAID. But how can you be sure? What about that tower you inherited from a hobbyist sysadmin who claims that it "has hardware RAID", but can't tell you what the RAID controller card is.

This might not work for everyone, but it's a good start. Comments are welcome; I'm happy to add more info to the original article.

This question on ServerFault is currently a prominent search result for "how can I tell if I'm using hardware or software RAID". I thought I'd contribute my personal experience and add that, in Linux, cat /proc/mdstat will show your software RAID configuration (assuming the md kernel module, which is probably a fairly safe bet).

If you're using software RAID, you'll see something like

Personalities : [raid6] [raid5] [raid4]
md0 : active raid5 sda1[0] sdd1[2] sdb1[1]
     1465151808 blocks level 5, 64k chunk, algorithm 2 [4/3] [UUU_]
    unused devices: <none>

(Snippet source and further reading.)

If not, you'll see

Personalities :
unused devices: <none>

You can also check the output of dmraid --sets, whose output is fairly clear (no RAID and you'll get no block devices found back).

Hardware RAID implementations vary. Some provide logical devices in /dev/sdX, some (like the Compaq Computer Corporation Smart Array 64xx (rev 01) in my HP Proliant) use /dev/cciss/c0d0.

Further reading:

 

(This post originally took the format of an answer on ServerFault, which unfortunately incurred the wrath of someone who hadn't yet had their morning coffee; I've converted it to this blog post in the spirit of learning and sharing.)